Cable Neutrik
 |
 20 Foot Canare Star Quad Patch Cable w Neutrik XLR M to 1 4  US $33.00
|
 20 Canare Star Quad Patch Cable w Neutrik 1 4 TRS US $32.50
|
 10 Mogami 2534 Neglex Quad Mic cable with Neutrik XLR US $30.50
|
 Hosa CMK 015 Microphone Cable XLR M F w Neutrik 15FT US $29.95
|
 Hosa CMK 020 Microphone Cable XLR M F w Neutrik 20FT US $29.95
|
 HOSA HMIC 050 Rean Neutrik Mic Microphone Cable 50FT US $28.98
|
 15 Foot Canare Star Quad Patch Cable w Neutrik XLR F to 1 4 US $28.50
|
 15 Foot Canare Star Quad Patch Cable w Neutrik XLR M to 1 4 US $28.50
|
 15 Canare Star Quad Patch Cable w Neutrik 1 4 TRS US $28.50
|
 Hosa CMK 005 Microphone Cable XLR M F w Neutrik 5FT US $26.95
|
 12 Canare Star Quad Patch Cable w Neutrik 1 4 TRS US $26.50
|
 8 Mogami 2534 Neglex Quad Mic cable with Neutrik XLR US $26.50
|
 Hosa CMK 003 Microphone Cable XLR M F w Neutrik 3FT US $24.95
|
 10 Canare Star Quad Patch Cable w Neutrik 1 4 TRS US $24.50
|
 20 Canare Digital 110 Ohm AES EBU Cable w Neutrik Gold US $24.00
|
 6 Canare Star Quad Patch Cable w Neutrik 1 4 TRS US $20.50
|
 5 Foot Mogami 2534 Neglex Quad Mic cable with Neutrik XLR US $20.50
|
What is the BEST way to wire my Ampeg SVT 4 Pro Bass head to my Cabinet Speakers.?
I have an Ampeg SVT 4 Pro Bass head that has 1600 watts.
My set up is currently an Ampeg PR 4X10hlf and also an Ampeg 1x15.
The 4x10 has 4 ohms and 650 watts rms and the 1x15 i think has 250 watts and is 8 ohms.
CURRENTLY i have it hooked up in stereo with a neutrik cable with head to the 410 and another to neutrik from head to 1x15.
someone help me out and tell me the best sound and power output that is completely safe.
THANKS
my band is
www.myspace.com/RemedyNewYork
That amp will drive 2 Ohms so you could just parallel both cabs together and run the amp as a mono bridged output.
The other option (like you have it) is to run each cab in the Biamp mode
You will get a bit more power if the cabs are paralleled, but it will be a 'mushier' sound with the lower impedance.
I would stick with what the manual recommends on page 13 for the BiAmp mode:
http://www.ampeg.com/pdf/SVT4PRO.pdf
.
How to Build a Speakon Cable using Neutrik Connectors
You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.
Comments are closed.